马鞍山市力长机械专业生产风管设备七功能咬口机

性能特点：
  本多功能咬口机（SA-12c）为技术成熟产品，电机与减速机一体化，以减少传动力流失，并具有结构简单，操作简便，低能耗等优点，适用于0.5-1.5毫米以下钢板的咬口加工。可根据需要加工咬制：单平口、直角骨、Z字骨、东洋骨、弯角、勾骨、C型插条本机械压制模具均采用模具钢经过热调质处理，经久耐用。
 
 咬口机机维护保养的方法
1、严格按照操作规程进行操作。
2、每次开机前按润滑图表要求定时、**、定量加润滑油，油应清洁无沉淀。
3、机床必须经常保持清洁，未油漆的部分应涂抹防锈油脂。
4、电动机轴承内的润滑漾油要定期更换加注，并经常检查电器部分工作是否正常安全可靠。
5、定期检查链条、手柄、旋钮、按键是否损坏，磨损严重的应及时更换，并报备件补充。
6、定期检查修理开关、保险、手柄、保证其工作可靠。
7、每天下班前10分钟，对机床加油润滑及擦洗清洁机床。
8、严禁非*人员操作该设备，平常必须做到人离机停。
 
Performance features:
The multifunctional bite mouth machine SA-12c for mature technology products, integration of motor and speed reducer to reduce power loss, and has simple structure, simple operation, low power consumption, etc. for in 0.5-1.5 mm below the plate bite processing. Can according to need to process bite of: single flat mouth, rectangular bone, Z word bone, Toyo bone, bending angle, tick off the bone, C type cutting the mechanical pressing mould are made of die steel after quenching and tempering heat treatment, durable.
Method of machine maintenance for bite machine
1, strictly follow the operation procedures for operation.
2, every time before the start of the lubrication chart to require the timing, fixed point, quantitative lubricating oil, oil should be clean without precipitation.
3, machine tools must often keep clean, the part of the paint should be coated with rust preventive grease.
4, motor bearing lubrication overflow oil should be changed regularly filling, and always check whether the normal work of safe and reliable electrical parts.
5, regularly check the chain, handle, knob, key press whether damage, wear serious should be replaced, and to spare parts for spare.
6, check the repair switch, insurance, handle, guarantee its work reliably.
10, 7 minutes before work every day, lubrication and cleaning machine tool for machine tools.
8, non designated personnel to operate the device, usually must be done to stop the machine.